Ver cesta (0 Producto) Mi cuentaMostrar lista de la compraIr a caja

In & Out® II

IN & OUT® II water soluble release agent will aid in releasing concrete or gypsum plaster castings from Smooth-On rubber molds. IN & OUT® II provides a clean, positive release and does not interfere with or affect surface detail and helps minimize air bubbles in finished castings.

Technical bulletin In & Out water soluble release

  • In & Out II water Suluable Release Agent for Concr

    IN & OUT II water soluble release agent will aid in releasing concrete or gypsum plaster castings from Smooth-On rubber molds. IN & OUT II provides a clean, positive release and does not interfer...

    14,95 EUR (precio sin 21% IVA .)

  • In&Out Medio despegante para cemento / 3,4 kgs

    IN & OUT ® II medio despegante a base de de agua que ayuda a despegar el hormigón o yeso de los moldes de caucho de Smooth-On.

    68,75 EUR (precio sin 21% IVA .)

  • In&Out Medio despegante para cemento /18,2 ltr

    IN & OUT ® II medio despegante a base de de agua que ayuda a despegar el hormigón o yeso de los moldes de caucho de Smooth-On.

    297,30 EUR (precio sin 21% IVA .)

Instructions

IN & OUT® II IS DILUTED WITH WATER.

Measuring & Mixing - Mix 4 parts water to 1 part In & Out II. Mixing can be done by hand or slow speed mixer. Do not shake or agitate as this may cause product to foam.

How you dilute IN & OUT II® (amount mixed with water, coverage and frequency of application) will depend on the concrete aggregate mix and the form material you are casting into. For example, when casting concrete with a low grit/high sand content (minimal abrasion) into a polyurethane mold, the mix ratio of water to IN & OUT II® can be 4 : 1. High grit content may call for a dilution ratio of 2 parts water to 1 part release agent.

Mix only amount needed for one day. Mixture may separate after 24 hours. Re-mix to a uniform consistency and apply.

Application - Apply IN & OUT® II thoroughly with brush, roller or spray. If pressure spraying, pressure should be 25 psi (172 kPa) or higher. For uniform spray applications of release agent, flat spray tips are suggested. Do not allow release agent to puddle.

Caution: Do Not Over Apply. Applying too much release agent will cause air bubbles “wormtracks”, “bugholes” or pitting on surfaces.

Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.

NederlandsEnglihDeutschFrançais

regístrese opcional



Facebook

En nuestra página de Facebook puede seguir los últimos comentarios de nuestros clientes y podrá ver nuestras ofertas y nuevos productos.

Marcas Aplicaciones Contacto Tarifas de envío Información Nuevo en..

su ventanilla única para materiales de modelado en 3D