Ver cesta (0 Producto) Mi cuentaMostrar lista de la compraIr a caja

One Step™

One Step™ is a convenient, economical liquid sealing agent and release agent in one. This low odor, low viscosity formula is offered as a “one step” alternative to using a sealing agent followed by a release agent during the mold making process using Smooth-On urethane mold rubbers. One Step™ will facilitate the release of cured urethane mold rubber from plaster, concrete, stone, brick, marble, limestone, wood, metal and other surfaces. Do not use on modeling clays.

  • One Step / 360 gr.

    Económico y cómodo agente de sellado y agente de desprendimiento, 2 en uno. Esta fórmula no es inflamable y se ofrece como una alternativa "de una sola aplicación". En lugar de usar un agente de sellado seguido de un agente de desmoldeo durante el proceso de fabricación de moldes ahora usamos un solo líquido.

    30,70 EUR (precio sin 21% IVA .)

  • One Step Selladory Despegante / 18,9 ltr.

    Económico y cómodo agente de sellado y agente de desprendimiento, 2 en uno. Esta fórmula no es inflamable y se ofrece como una alternativa "de una sola aplicación". En lugar de usar un agente de sellado seguido de un agente de desmoldeo durante el proceso de fabricación de moldes ahora usamos un solo líquido. 18,9 ltr

    290,15 EUR (precio sin 21% IVA .)

Features
Low Viscosity Liquid – goes on easily and thoroughly coats any surface when used as directed
Easy To Use – Apply with brush or Kwikee™ pressurized sprayer
Non-Hazardous formula – Does not incur hazardous shipping costs
Economical – Buy one product, not two
Instructions
Safety - Use in a properly ventilated area (“room size” ventilation). Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk. Use in low humidity environments. High humidity will slow evaporation of solvents. Application surface should be clean, dust free and dry. Shake container well before each use.

Store and use material at room temperature (73°F/23°C).

How To Apply - Use a dry brush to apply thorough thin coating of One Step™ over entire surface of model and any surfaces that will contact the mold rubber. Brush into deep detail and undercuts on the model.

Do not allow to pool. Blow off excess with compressed air. Let dry 15 minutes. Apply a second coating and let dry 30 minutes. Mix and apply urethane rubber as directed by the rubber product technical bulletin.

Note: if sealing an extremely porous surface (such as pressed brick), apply 3 coats of One Step™ before applying mold rubber.

Because no two applications are the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.

NederlandsEnglihDeutschFrançais

regístrese opcional



Facebook

En nuestra página de Facebook puede seguir los últimos comentarios de nuestros clientes y podrá ver nuestras ofertas y nuevos productos.

Marcas Aplicaciones Contacto Tarifas de envío Información Nuevo en..

su ventanilla única para materiales de modelado en 3D