Ver cesta (0 Producto) Mi cuentaMostrar lista de la compraIr a caja

Silicone Thinner®

Silicone Thinner® is a non-reactive silicone fluid that will lower the mixed viscosity of tin cure (condensation) or platinum cure (addition) silicone rubber products.

  • Silicone Thinner / 410 gr.

    Mold Max Thinner, es un aceite universal para aplicar a todo tipo de siliconas. No solo modifica el espesor de la silicona haciendo que sea menos viscosa sino que también modifica un poco su dureza haciendo que sea mas blanda. Bote 410 gr.

    23,85 EUR (precio sin 21% IVA .)

  • Silicone Thinner / 18,14 kg.

    Mold Max Thinner, es un aceite universal para aplicar a todo tipo de siliconas. No solo modifica el espesor de la silicona haciendo que sea menos viscosa sino que también modifica un poco su dureza haciendo que sea mas blanda. Bidón 18,14 kg.

    416,25 EUR (precio sin 21% IVA .)

Features

Silicone Thinner® offers the following advantages:

A lower mixed viscosity (A+B) means that the rubber will de-air faster when vacuuming.
Mixed rubber (A+B) will flow better over intricate model detail.
Silicone Thinner® will lower the ultimate shore hardness (durometer) of cured silicone rubber.
Pot life (working time) is increased in proportion to the amount of Silicone Thinner® used.

Disadvantage: Ultimate tear and tensile strength are reduced in proportion to the amount of Silicone Thinner® added, however knotty tear properties of the Mold Max® series rubbers are unaffected.
Instructions

Materials should be stored and used in a warm environment (73° F / 23° C). This material has a limited shelf life and should be used as soon as possible. Wear safety glasses, long sleeves and rubber gloves to minimize contamination risk.

*Silicone Thinner® is added as a percentage of the total Part A+Part B rubber system. An accurate gram scale must be used. Weigh out and pre-mix required amount of Silicone Thinner® with Part A of silicone rubber before adding Part B. Mix all components thoroughly and vacuum as directed on mold rubber technical bulletin.

It is not recommended to exceed 10% by weight of total system (A+B).

Because no two applications are quite the same, a small test application to determine suitability for your project is recommended if performance of this material is in question.

Ayuda para elegir

Todos nuestros productos enumerados por aplicaciones: "Lifecasting", Escultura, Moldes, Fundición, Maquillaje FX, Réplicas, Dientes y Kits de aprendizaje.

Información Contacto Tarifas de envío Proyectos Clientes Marcas Aplicaciones Branches

su ventanilla única para materiales de modelado en 3D