DragonSkin10 Medium / 0,9 kg

DS 10 Medium / 0,9 kg.

Dragon Skin Medium es una silicona de curado de platino de consistencia gelatinosa y translucida. Tiene 20 minutos de trabajo y endurece a las 5 horas. Es muy blanda, elástica y muy resistente a la rotura, se utiliza en moldes y efectos especiales en la fabricación de prótesis y animatrónicos. Se mezcla en volúmenes iguales y tiene una dureza: Shore A/10. A+B= 0,9 kg.

Instructions

Measuring and Mixing - Before you begin, pre-mix Part B thoroughly. After dispensing required amounts of Parts A and B into mixing container (1A:1B by volume or weight), mix thoroughly for 3 minutes making sure that you scrape the sides and bottom of the mixing container several times. After mixing parts A and B, vacuum degassing is recommended to eliminate any entrapped air. Vacuum material for 2-3 minutes ( 0,98 bar), making sure that you leave enough room in container for product volume expansion.

For best results, pour your mixture in a single spot at the lowest point of the containment field. Let the rubber seek its level up and over the model. A uniform flow will help minimize entrapped air. The liquid rubber should level off at least 1.3 cm over the highest point of the model surface.

Curing / Post Curing - Allow rubber to cure as prescribed at room temperature 23°C before demolding. Do not cure rubber where temperature is less than 18°C. Optional: Post curing the mold will aid in quickly attaining maximum physical and performance properties. After curing at room temperature, expose the rubber to 80°C for 2 hours and 100°C for one hour. Allow mold to cool to room temperature before using.

More information about Dragon Skin:

dragonskintb.pdf [19 KB]